Short answer
Most homes use a conventional system: a septic tank feeding a gravel or chamber drain field. When the soil is too shallow, too wet or too small for that, designers turn to alternatives such as mounds, sand filters, aerobic treatment units or drip systems. Alternatives treat wastewater more thoroughly but usually cost more to install and need yearly service.
There are two broad types of septic systems: conventional systems, which use a septic tank and a gravel or chamber drain field, and alternative systems, which add extra treatment or a different way to spread wastewater. EPA lists nine common designs: conventional, chamber, drip distribution, aerobic treatment unit, mound, recirculating sand filter, evapotranspiration, constructed wetland and cluster systems. Which one you can use depends mostly on your soil, water table and lot size.
How septic system designs differ
Every septic system does the same two jobs. First, a tank or treatment unit removes solids. Then the liquid, called effluent, is spread into soil or another medium that finishes the cleaning. The designs differ in how much treatment happens before the soil and how the effluent is delivered.
EPA explains that alternative systems use pumps or gravity to move effluent through sand, peat, constructed wetlands or other media. Some evaporate the water or disinfect it before it is released. These extra steps let a system work on sites where a conventional drain field would fail, such as land with shallow bedrock, a high water table or a stream nearby.
If you are new to septic, start with what a septic system is, then come back here.
Comparison table: types of septic systems
| System type | Best for | Typical installed cost | Cost tier | Maintenance |
|---|---|---|---|---|
| Conventional (gravel) | Deep, well-drained soil and enough yard space | $3,000 to $8,000 | Low | Low: pump every 3 to 5 years, inspect every 3 years |
| Chamber (gravelless) | High groundwater, vacation homes, places where gravel is scarce | $5,000 to $12,000 | Low to medium | Low: same as conventional |
| Drip distribution | Shallow soil where a mound is not wanted | $8,000 to $18,000 | Medium to high | Medium to high: dose tank, pump and power |
| Aerobic treatment unit (ATU) | Small lots, poor soil, high water tables, sites near lakes or streams | $10,000 to $20,000 | High | High: ongoing service, yearly inspection |
| Mound | Shallow soil, high groundwater or shallow bedrock | $10,000 to $20,000 | High | Medium: pump chamber and periodic checks |
| Recirculating sand filter | High water tables, sites near water bodies | $7,000 to $18,000 | Medium to high | Medium to high: pumps and filter media |
| Evapotranspiration | Dry, sunny climates with shallow soil | $10,000 to $15,000 | High | Medium |
| Constructed wetland | Sites that can support a lined, planted treatment cell | $5,000 to $12,000 | Medium | Medium: plant and media care |
| Cluster or community | Subdivisions or groups of homes sharing one system | Varies; costs are shared | Varies | Usually handled by a shared management entity |
Costs are national ranges from This Old House (March 2026), where “conventional” is the anaerobic (traditional) system. Maintenance notes are based on EPA guidance. Local prices vary a lot with soil, access, permits and region. For an estimate for your property, use the septic system cost calculator or read the full septic tank installation cost guide.
Conventional septic systems
A conventional system is a septic tank followed by a gravel or stone drain field. EPA describes it as the typical system for a single-family home or small business. The tank holds wastewater so solids settle and grease floats. The middle liquid flows into perforated pipes buried in gravel-filled trenches, then seeps into the soil.
Penn State Extension notes two common layouts for the field: standard trenches, which are 12 to 72 inches wide and follow the contour of the land, and seepage beds, which are wider rectangular excavations.
The catch is space. EPA says conventional systems have a relatively large footprint and may not suit every site. They also need enough unsaturated soil below the trenches. Pennsylvania, for example, requires at least 4 feet between the bottom of the gravel and groundwater or bedrock.
For how the tank side works, see our guide to the septic tank.
Chamber septic systems
A chamber system replaces the gravel with open-bottom plastic chambers connected end to end and covered with soil. Effluent flows into the hollow chambers and soaks into the soil below.
EPA says chamber systems work well in areas with high groundwater, for homes with uneven use such as vacation homes, and where gravel is scarce or costly. Their main advantage is that the light chambers are easier to deliver and install than truckloads of stone. Care is the same as for a conventional system.
Drip distribution systems
A drip system pumps effluent through small tubes, called drip laterals, buried in the top 6 to 12 inches of soil. Because the tubing is so shallow, EPA notes that no large mound is needed on sites with thin soil.
The trade-offs: drip systems need a large dose tank after the septic tank to hold effluent between timed doses, plus electrical power and controls. EPA says those parts add cost and maintenance.
Aerobic septic systems (aerobic treatment units)
An aerobic septic system uses an aerobic treatment unit, or ATU, which pumps air into the wastewater. The oxygen feeds bacteria that break down waste faster and more completely than the oxygen-free bacteria in a standard tank. EPA compares it to a small version of a municipal treatment plant. Some ATUs also disinfect the water before it is released, for example to a spray field, which is common in parts of Texas.
EPA says ATUs suit homes with small lots, poor soil, high water tables, or a nearby lake or stream that needs extra protection. They are also among the more expensive designs, at about $10,000 to $20,000 installed according to This Old House.
The main drawback is upkeep. EPA says “regular life-time maintenance should be expected,” and recommends a service contract and yearly inspection for any system with pumps, float switches or mechanical parts. Some states require a maintenance contract. In Texas, for example, Texas A&M AgriLife Extension notes that homeowners may service their own ATU only in counties that allow it. Because an ATU has a blower and an alarm, our guide to a septic alarm going off is worth bookmarking if you have one.
Mound septic systems
A mound system is built above the natural ground. Effluent from the septic tank goes to a pump chamber, which doses it in measured amounts into a raised bed of sand covered with soil. The sand provides the treatment depth that the natural soil lacks.
EPA says mounds are used where soil is shallow, groundwater is high or bedrock is close to the surface. Penn State Extension notes that in Pennsylvania, the sand adds the depth needed to meet the state’s 4-foot separation rule.
Downsides: mounds take a substantial amount of space, according to EPA, and need periodic maintenance of the pump and controls. They typically cost $10,000 to $20,000.
Recirculating sand filter systems
In a sand filter system, effluent from the tank is pumped under low pressure through a bed of sand, either in a lined box above ground or in a buried container. The water is often recirculated through the sand more than once before going to the drain field. EPA says this provides a high level of treatment, including nutrient removal, which makes it a fit for high water tables and lots near lakes, rivers or the coast.
EPA notes these systems cost more than a conventional system. This Old House puts sand filters at about $7,000 to $18,000.
Evapotranspiration systems
An evapotranspiration system uses a drain field lined with a watertight material, so effluent never reaches the soil below. Instead, the water evaporates from the surface or is taken up by plants and released through their leaves.
EPA says these systems only work in arid climates with enough heat and sunlight, and they can be a good fit where soil is shallow. EPA also warns they are at risk of failure if it rains or snows too much.
Constructed wetland systems
A constructed wetland mimics a natural marsh. Effluent from the septic tank flows into a lined cell filled with gravel, sand and wetland plants. Microbes, plant roots and the media clean the water. EPA says the wetland can use gravity or pressure to distribute effluent, and the water may go on to a drain field afterward. The plants must be species that tolerate constantly wet conditions.
Cluster and community systems
A cluster system serves two or more homes. Wastewater from each house is piped to a shared treatment and dispersal area under some form of common ownership. EPA says cluster systems are common in rural subdivisions. If you buy into one, ask who owns and maintains it, how fees are set, and what happens if repairs are needed.
How to find out what type of septic system you have
- Check your permit records. Your county or local health department usually has the original permit and a site drawing.
- Look for clues in the yard. A raised, grassy hump suggests a mound. A control panel or outdoor alarm box points to a system with a pump or ATU. Sprinkler-like heads in the lawn often mean an aerobic system with a spray field.
- Ask the pumper or inspector. A septic inspection records the type, the tank size and the condition of each part.
Whatever type you have, the basics are the same: pump on schedule, keep the drain field clear of cars and trees, and call a licensed professional if an alarm sounds or sewage appears. Rules on which systems are allowed vary by state and county, so your local health department has the final say on any new or replacement design.
Common questions
What is the most common type of septic system?
The conventional system, a septic tank plus a gravel or gravelless drain field. EPA describes it as the typical setup for a single-family home or small business.
Who decides which type of septic system I get?
Your site does. A soil evaluation and perc test, reviewed by your state or county permitting office, determine which designs are allowed on your lot. A licensed designer or engineer then draws the plan.
Do aerobic septic systems need electricity?
Yes. An aerobic treatment unit uses an air pump or blower to add oxygen, so it runs on power and has an alarm. Drip, mound and sand filter systems usually rely on pumps too.
Can I switch from a conventional system to a different type?
Only with a permit, and only to a design your soil and lot can support. A new soil evaluation may point to a different type than the original, so check with your local health department first.
Sources
- EPA: Types of Septic Systems
- EPA: How Your Septic System Works
- EPA: How to Care for Your Septic System
- EPA: Frequent Questions on Septic Systems
- Penn State Extension: Septic System Basics
- This Old House: How Much Does a Septic Tank Installation Cost?
- Texas A&M AgriLife Extension: Homeowner Maintenance of Aerobic Treatment Units